| |
 |
 |
Obtain up to 10-25% more power in your turbo- or supercharged engine, even if it´s pre-tuned, by using the Boost Cooler™-Water/Methanol Injection System!
The main function of the Boost Cooler is to suppress detonation caused by high temperature and pressure developed within the combustion chamber when the effective compression ratio has been taken beyond the auto-ignition point by either a turbo or a supercharger.
Water, with its high latent heat content, is extremely effective for controlling not only the onset of detonation but also the production of oxides of nitrogen in the modern leanburn engines.
Furthermore, the Boost Cooler doesn't create an intake restriction like an intercooler, and unlike race gas, it reduces intake air temps up to 60°C and improves charge air density too!
Snow Performance systems effectively steam clean the valves, valve seats, and even the piston tops and intake when they inject. This reduces carbon build up.
The Boost Cooler™ can be installed in a matter of hours without having to remove bumpers or do custom intake piping. | |
 |
 |
Boost controlled, variable injection
Efficient Intercooling, up to 60°C
lower air intake temperature
Achieve approx. 116-Octan rating,
by using ordinary 95-Octan gasoline
Reduces EGT and oil temperatures
Allows you to run safely more boost
and/or more timing
Reduces thermical stress on NOS,
LPG/Autogas and pre-tuned engines
like chiptuning & higher boost levels.
No wear issues, only clean
combustion chambers
No loss of boost as with an intercooler
Reduces the specific fuel consumption
Easy Installation
| |
 |
 |
 |
 |
 |
 |
 |
Like the Stage-2 low boost system, this kit uses manifold boost pressure to determine when and how much fluid to inject. Proportionally injecting according to boost pressure gives the most accurate delivery of water-methanol and allows the most cooling and performance improvement over the widest range. More power and driveability is the result! It can be used on any forced induction engine. The most suitable are the centrifugal supercharged and turbocharged engines, as they build boost is a more progressive manner concerning water-methanol injection.
For lower boost applications (below approx. 25psi), we´re recommending the Boost Cooler Stage 2 VC25MAF low boost kit or the Stage 3 LCD system which will perfectly work in each condition. | |
 |
 |
 |
|
|
|
|
|
|
| Boost Cooler Waterinjection Stage 2 - High BoostFor high boost engines (>1.7bar) - With variable Injection and 220psi 12v-Pumpsystem!
| Art.No.: | SP10202 | | Delivery time: |  |
This product variant can not be found. Alternatively, we offer you the following product
|
| |
| | |
